The UK Dart 15 Association

Jib Set-up

Dart 15 Chat
Post Reply
simon
Captain
Captain
Posts: 202
Joined: Fri May 06, 2011 6:47 pm

Jib Set-up

Post by simon »

Hi All
Set the jib up on 2026 today, is there any dimentions for the cleat position along the tramp track.
I have arrived at a position using the diagram in Brians "Catamaran Book",the position I arrived at was- from the inside of the rear beam to the centre hole of the mounting plate was 740mm, seemed quite a long way back, but that was where it worked to be.
I will give things a try on Wednesday evening, but in the mean time any advice would be appreciated,
Thanks in advance
Simon
User avatar
Liam
Site Admin
Site Admin
Posts: 976
Joined: Sat Aug 01, 2009 7:23 am
Location: Isle of Wight
Contact:

Re: Jib Set-up

Post by Liam »

Mine is set right by the trapeze bungee. If I knew what I was doing I would move it for different wind conditions.
2034 - No Quarter, 1957 - Dreadnought, 1709 - Biscuit
Shanklin Sailing Club
Holder of OTT Shield
9th most improved at 2018 Nationals
simon
Captain
Captain
Posts: 202
Joined: Fri May 06, 2011 6:47 pm

Re: Jib Set-up

Post by simon »

Thanks for that Liam,
I will move mine as in the current position I could possibly spent a lot of time sitting on /over them. Will use your position as a starting point and adjust them to see what works best. I think the both the tell tales should be flying when its right.
Kevin Dutch
Lieutenant Commander
Lieutenant Commander
Posts: 164
Joined: Mon Jul 16, 2007 9:08 am
Location: Seasalter sailing club

Re: Jib Set-up

Post by Kevin Dutch »

I have mine near the trapeze elastic too
1938 Flying Dutchman
@sprint151938
Gordon Deuce
Leading Rate
Leading Rate
Posts: 16
Joined: Tue Apr 12, 2011 1:16 pm

Re: Jib Set-up

Post by Gordon Deuce »

Simon,

If in doubt see the instructions. The manual states 525mm from the end of the track. Hope that helps to start with.
simon
Captain
Captain
Posts: 202
Joined: Fri May 06, 2011 6:47 pm

Re: Jib Set-up

Post by simon »

Hi Guys
Thanks for the info, missed the 525mm in the instructions.
Post Reply
cron